Polishing Agent

Chemical solution LQ-A410

This product can efficiently make the workpiece achieve high brightness effect. This product is the latest chemical polishing technology, replacing the traditional three-acid process, no yellow smoke on the production site, to meet the environmental requirements. This product light fast, stable production, to meet the automatic polishing effect.

Tank management:

Ratio: general use method (depending on the situation of each factory will be different, for reference)

Note:

• There are some materials and workpieces in automatic throwing because of the material and the workpiece with holes, easy to produce punching, punching and other bad, need
• To throw the anti-punching agent LQ-A420 to be auxiliary use, the dosage is about 0.5% to 2%, or according to the workpiece punch
• Hole degree to add. In addition, if there is a flow mark, the anti-flow mark additive LQ-A430 should be added, and the dosage is about 0.5% to 2%.
• Or according to the degree of punching the workpiece to add.

Use and maintenance

1, After washing oil or other precipitates with stainless steel mesh filtration, it is recommended to replace the water one to two days
Wash the sink.
2, It is recommended to wash at least two times after chemical disposal and then enter the neutralization.
3, Be careful not to bring too much water into the workpiece, affecting the specific gravity of the solution.
4. This product is acidic and corrosive. Pay attention to protection during production, if there is a splash on the skin, immediately flush with water
For washing.
5, For the new acid solution, must first dissolve a certain amount of aluminum ions, in order to get the best luster.

Packing specification:

Plastic drum packing 30kg/barrel or 1500kg/barrel. Light loading and unloading to prevent heavy pressure inversion. Store at room temperature in a well-ventilated place